New dust removal method for vibrating screen

Most of the Dust removal method of supported type vibrating screen in our country is cloth bag dust removing technology, which includes cover dust catcher, pipelines, cloth bag dust collector, induced draft fan and chimney, etc. The advantage is high dust removal efficiency. However,the disadvantage is large investment, low dust collecting rate, easy blockage of horizontal pipeline, large pumping air volume, high operating cost, big occupied area of dust catcher,induced draft fan and chimney, besides, it needs to set up full-time operation& maintenance personneland the dust transport equipment.
In order to solve the above problem, we have researched a new resolution with high rate of dust removal system, low processing cost, long service life, less investment, small area coverage and short construction period.
The new dust removal method offers secondary dust removal for supported type vibrating screen.Primary dust removal equipment will fixed above the vibrating screen,collected dust will enter into vibrating screen; Secondary dust removal equipment will be placed near vibrating screen and remove dust by itself.

Primary dust removal: seal the supported type vibrating sieve surface and set a dust filter above it,set up an efficient filter bag to filter the air, clean air will be discharged through 3.0 kW fan, thus dust will enter into the vibrating screen through the bottom of the filter. Vibrating screen drives sieve surface vibration,while the dust filter is fixed, so one moveswhile the other one not, both connected by the pipe, the joint connection adopts rubber to reduce the vibration.
Secondary dust removal: Seal the supporting type vibrating screen and dust removal joint, leave a open mouth to connect the pipe for conveying the escaped dust into the secondary dust filter,set a high efficient dust filter bag to filter the dust, and then the clean air will be discharged through 3.0 kW fan, then the dust is discharged from the filter at the bottom of the tube and the valve.

What should We do to Use #Vibrating #Feeder Safely?

Are you obtaining the correct methods to operate the vibrating feeder safely? Following mentioned points are the matters users should notice during operation,we are sure you will benefit a lot!   Firstly, lubrication
Regular maintenance and overhaul are important means of extending the service life of the machine and ensuring the normal work, users should attach importance to it. For lubrication, users should pay attention to the following two points:
1.The machine adopts thin oil splash lubrication, the lubricant should be determined according to the use place, temperature conditions. General used oil is gear oil;
2.Make sure that the exciter in the thin oil is higher than the standard height (filling by joint bend), oil must be replaced every three to six months, when we change the oil, please use clean gasoline or kerosene to clean the oil tank, bearing raceway and gear surface. Secondly, we need to be aware of safety technology of the following points during use:
1. The machine operators should subject to security technology education;
2. Reinforce all the bolts to prevent the looseness in the operation process;
3. Often view the amplitude of the vibration motor, if it is unusual, immediately stop and repair.
4. When the vibrating feeder is running, it is forbidden to stand beside the machine, touch, adjust, clean or inspect the machine and so on;
5. Equipment should be grounded, wire should be reliably insulated, and packed in a snakeskin tube, we should often check whether the motor wiring wears and leaks of electricity.