In our company, there will be individual customers often call me to ask some information today explained one: Vibrating screens will appear in the course of the screen surface has a material accumulation phenomenon. So what is causing this phenomenon is the reason? Pingyuan mining mechanical engineer for detailed analysis of the phenomenon based on years of experience, can be attributed to four reasons:
1, the screen and the discharge port are in the same height? Under normal circumstances should be level or higher than about 6mm, depending on the material discharge port design are not the same height.
2, mesh shaker screen of choice if there are problems? Mesh mesh screen is too small will cause the material through network rate.
3, shaker vibration motor angle adjusting Is there a problem? Improper adjustment of the angle of the vibration motor can also cause material accumulation phenomenon, the smaller the angle on the screen surface material spread outward run faster, whereas angular displacement of the General Assembly to make the material spread out slow. If you are under strict requirements for screening accuracy, the motor angle should not be too small, so as not to affect the accuracy of screening, in general, the factory motor shaker angle of 45 °, the user can also special screening process based on its material Requirements will adjust the vibration motor angle to 100 °, the mesh material is centralized.
4. Check if the shaker is placed on the ground level, high spout will affect the operation of track material, causing the material to one side.
1, the screen and the discharge port are in the same height? Under normal circumstances should be level or higher than about 6mm, depending on the material discharge port design are not the same height.
2, mesh shaker screen of choice if there are problems? Mesh mesh screen is too small will cause the material through network rate.
3, shaker vibration motor angle adjusting Is there a problem? Improper adjustment of the angle of the vibration motor can also cause material accumulation phenomenon, the smaller the angle on the screen surface material spread outward run faster, whereas angular displacement of the General Assembly to make the material spread out slow. If you are under strict requirements for screening accuracy, the motor angle should not be too small, so as not to affect the accuracy of screening, in general, the factory motor shaker angle of 45 °, the user can also special screening process based on its material Requirements will adjust the vibration motor angle to 100 °, the mesh material is centralized.
4. Check if the shaker is placed on the ground level, high spout will affect the operation of track material, causing the material to one side.
没有评论:
发表评论